New Items

It is a BO Series 110RPM DC Motor Plastic Gear Motor. The BO series straight motor gives good torque and rpm at lower operating voltages, which is the biggest advantage of these motors.

A small shaft with matching wheels gives an optimized design for your application or robot. Mounting holes on the body & lightweight makes it suitable for in-circuit placement. This motor can be used with 69mm Diameter Wheel for Plastic Gear Motors and 87mm Diameter Multipurpose Wheel for Plastic Gear Motors.

Low-cost geared DC Motor. It is an alternative to our metal gear DC motors. It comes with an operating voltage of 3-6V and is perfect for building small and medium robots.

The motor is ideal for DIY enthusiasts. This motor set is inexpensive, small, easy to install, and ideally suited for use in a mobile robot car. They are commonly used in our 2WD platforms.

We are supplying the range BO(Battery Operated) Motors with varying RPM and Gear-Box arrangement, click on the name below for more information

BO Motors

1. Cost-effectiveness of the injection-molding process.
2. Elimination of machining operations.
3. Low density: lightweight, low inertia.
4. Uniformity of parts.
5. Capability to absorb shock and vibration as a result of elastic compliance.
6. Ability to operate with minimum or no lubrication, due to inherent lubricity.
7. The relatively low coefficient of friction.
8. Corrosion-resistance; elimination of plating, or protective coatings.
9. The quietness of operation.
10. Tolerances are often less critical than for metal gears, due in part to their greater resilience.
11. Consistency with the trend to greater use of plastic housings and other components.

CNC 3D Printer Mech Endstop Switch uses a lever switch to detect when it is activated. The switch is wired up so that when activated, it pulls the signal to LOW. There is also an LED on the board that will light up when the switch is activated. It uses a standard 4 pin 100″ pitch header and accepts a standard, old-style CD-ROM audio connector cable.

The mechanical endstop is a simple solution to a simple problem. We want to be able to detect when an X/Y/Z stage has reached its minimum or maximum. Instead of messing with flags or complicated light beam interruption, we use a mechanical switch.

If we place the switch in the path of the stage, then the stage itself will simply close the switch when it moves against it. Other than properly positioning the switch, we do not need to modify the stage at all. If you’re worried about reliability, you can sleep well at night. The switches we use are rated for 1 million operations before failure. Since we only use the switches once per print, that means you’ll be able to do one million prints before having to replace the switch

• Redline: connecting VCC (ramps of +)
• Black line: connecting GND (ramps of -)
• Green Line: connecting SIGNAL (ramps in s) 

1. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug.
2. Quality switching elements.
3. Customized high-quality connection wires using 22AWG copper wire with ratings of current 2A, 300V voltage.
4. An insulating layer over a wide range of temperatures, up to 80 degrees.

This is 9V Battery Connector Snap. It is used to connect a 9V battery to the required application. This snap power cable to DC 9V clip male line battery adapter for mostly used to power Arduino boards as well as many development boards.

The connector comes with open-wire at one end and battery connector at another end. It is very good practice to use such a connector in the project as they provide various benefits such as avoid short circuits, No chance of mismatch polarity as wire comes in red and black color, optimum battery use, easy to connect and disconnect the battery to the application, etc.

1. Made of hard leather.
2. Excellent material, fine workmanship.
3. It is an environmental 9V battery buckle.
4. Color: Blue.
5. Avoid the polarity conflict and short circuit.